[DaRod]

Hello everyone. Currently replacing a wire harness pin connector #47 which is housed in the X3 terminal box of the underhood fuse box. I cannot get the wire to slide out of the terminal block. Any tricks to this procedure?

 

[ibis1]

Hello everyone. Currently replacing a wire harness pin connector #47 which is housed in the X3 terminal box of the underhood fuse box. I cannot get the wire to slide out of the terminal block. Any tricks to this procedure?

I'm not sure which connector you are looking at, but all wires are held in the connector body by a locking tab or strip. You may need to get a magnifying glass to see it. It would be helpful if you could supply a few up-close photos. Good luck.