EnclaveForum.net: Buick Enclave Online Community banner
1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
2014 Enclave:
It started with the passenger side blind zone alert would turn on and stay on, then go off.
3 weeks later both sides now don’t come on at all.
Also now when we put on the turn signal, the signal will blink normal 4 times. Then pause for a few seconds, then continue. It repeats that cycle.

Am I looking at that passenger blind zone control module being bad? If so how would I test it. Also if I get a new one, would it need to be programmed by the dealer?
Thanks,
Sam
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
I just fixed mine. Used same exact modules bought from Ebay. These were used. Was easy enough. Ran my scan tool on it to determine which side lost signal.
Thanks for the response.
After you put the used one in, there was no need to "program it" to sync with your Enclave's computer? Just pluged it in and your car recognized it with no further issue?
Thanks,
Sam
 
1 - 4 of 4 Posts
Top