EnclaveForum.net: Buick Enclave Online Community banner
1 - 5 of 5 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
Is there a way to make or adjust the right projector lamp back towards center? Mine is shining to the right. I have tried up down and there is a yellow adjuster nut towards the back of the headlight assembly. It shines off into the ditch and beyond in stead of on the road. Car has not been in any accident. Thank you in advance.
2015 Enclave leather FWD non articulating headlights only projector with D3S bulbs
 

·
Registered
Joined
·
170 Posts
I'll give you a bump because, after replacing my D3S bulbs in my 2016 Enclave with articulating headlights, the right is shining too far to the right and the left is too far to the left! I see and have used the vertical adjustment, but I'd like to be able to adjust them laterally.
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #3 ·
All I know is I can not find any way to make them align left to right only up /down. I have looked all over the web. As far as I can tell there is no left /right adjustment.
 

·
Registered
Joined
·
1 Posts
I'll give you a bump because, after replacing my D3S bulbs in my 2016 Enclave with articulating headlights, the right is shining too far to the right and the left is too far to the left! I see and have used the vertical adjustment, but I'd like to be able to adjust them laterally.
My articulating headlight calibrate every time the car starts, testing the extreme left and right and settling in the middle.
 

·
Registered
Joined
·
170 Posts
My articulating headlight calibrate every time the car starts, testing the extreme left and right and settling in the middle.
Well, mine also go through that swiveling action upon startup, but they end up with the left being too far left and the right too far to the right. I don't remember it being like this before I replaced the bulbs. I did notice that when I was inserting the new bulbs, the actual projector was moving left and right as I was trying to fully insert the bulbs. My thought was that that threw off the horizontal aim. Anyway, is there any way to adjust the horizontal aim of the bulbs?
 
1 - 5 of 5 Posts
Top