EnclaveForum.net: Buick Enclave Online Community banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Own a 2009 Buick Enclave, purchased manufacturer towing wire harness, all installed, went to install fuses in fuse panel and there are no sockets for all fuses for trailer package. Its empty and unable to hold fuse. Now what??
 

·
Registered
Joined
·
76 Posts
This is an add on tow system from Buick? Was it installed by tapping into the brake wires and taillight wires already in the rear of your car? If so any fuses would be in line fuses that would be in the new wires you installed. There wouldn’t be any fuses to put in the panel. Do the lights all work when you hook up your trailer?
 

·
Registered
2015 Enclave Leather.
Joined
·
839 Posts
I am not 100% sure but I believe that what you need to do is get yourself a new fuse block which has the towing wiring option. Not sure of the option number but the wires should be there from the fuse block connector to the hitch connector.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top