EnclaveForum.net: Buick Enclave Online Community banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
So I'm working on an 08 enclave with 3.6. I am getting code p0019. What's is most likely the problem.i have replaced bank one solenoids one cam sensor in bank 2 exhaust. I can't seem to find any info one just the one code. Any help would be great. My next thought was crank sensor.
 

·
Registered
Joined
·
6,039 Posts
“Crankshaft Position – Camshaft Position Correlation Bank 2 Sensor 'B'.” This code is set when the vehicle's primary computer (also referred to as the powertrain control module or PCM) perceives that the crankshaft and the bank 2 exhaust camshaft are out of sync.
 
1 - 2 of 2 Posts
Top